Verification and validation are independent procedures that are used together for checking that a product, service, or system meets requirements and specifications and that it fulfills its intended purpose. In the development phase, verification procedures involve performing special tests to model or simulate a portion, or the entirety, of a product, service or system, then performing a review or analysis of the modeling results. In the post-development phase, verification procedures involve regularly repeating tests devised specifically to ensure that the product, service, or system continues to meet the initial design requirements, specifications, and regulations as time progresses.
Admatis' task do not stops after manufacturing a product, the verification and ispection are also our responsibility. To verify component geometry we use 3D measurement. In the space industry, the quality of satellite component coatings is also very important. Admatis conducts many tests to verify the coating, in case of some tests special test adapters required. Designing and manufacturing these test adapters are also carried out by Admatis.